Location : Homepage / Products / Gear oil series / Ordinary open gear oil
Ordinary open gear oil
Ordinary open gear oil
This product is a non-dilution type ordinary open gear oil. It is refined from the following ways to mineral oil as the base oil and add rust, corrosion and other additives and the amount of asphaltene.
The product is suitable for open gear, chain and rope lubrication. The product is divided into 68,100,150,220,320 five grades by viscosity points.
Quality index:
| Items | Quality index | Test method | ||||
|
Viscosity grade(Divided by 100℃ kinematic viscosity) |
68 | 100 | 150 | 220 | 320 | - |
| Similar to the original brand | number 1 | number2 | number 3 | number 3 | number4 | - |
| Kinematic viscosity（100℃）/mm2/s | 60-75 | 90-110 | 135-165 | 200-245 | 290-350 | See appendix A |
| Flash point(opening).℃ not lower than | 200 | 200 | 200 | 210 | 210 | GB/T267 |
| Corrosion test (45 steel sheet 、100℃、3h) | qualified | SH/T0195 | ||||
| Liquid phase corrosion test (distilled water) | No rust | GB/T11143 | ||||
| Maximum no card bite load (PB).N(kgf) not less than | 686（70） | GB/T3142 | ||||
| Cleanliness | Must have no sand and abrasive | 1） | ||||
Second, Marking, packaging, transportation, storage and transportation
Marking, packaging, transportation, storage and delivery acceptance by SH0164.
Third, sampling
Sampling according to GB/T4756 for 2L for inspection and retention.
相关产品
-
HN-69-1 Emulsification Cutting fluid -
HN-M9 Machining Center Emulsification Cutting fliud -
HN-R1 Grinding & Antirust Emulsification Cutting fliud -
HN-R1A Grinding & Antirust Emulsification Cutting fliud -
HN-R1B Line Cutting Emulsification fliud
-
HN-R1C Copper Wire Drawing fluid
